Thread: tie rod
View Single Post
  #5 (permalink)  
Old 05-25-2011, 10:39 AM
VENOMOUS1 RACING's Avatar
VENOMOUS1 RACING VENOMOUS1 RACING is offline
VIPER POWERED
Southwest VTCoA Regional Member
Southwest VTCoA Regional Rep
2013 Viper Truck of The Month
 
Join Date: May 2009
Location: Wacko Waco,TX
Age: 43
Posts: 12,687
Member #10675
Quote:
Originally Posted by HaroldD View Post
I'd guess 7 or 8 degrees.

Measure the large hole, small hole, and depth with a micrometer. Break out the geometry book.

Here's my best shot without any ritas onboard. Each side is a right triangle. I visualize the edge of the large hole end as the tip of the triangle, draw an imaginary line through the spindle metal toward the small hole end, then the length of your right angle end of the triangle is 1/2 of the difference between the two diameters.

tan (A) = 1/2(L-S)/T

where A is your angle, L is large diameter hole, S is small diameter hole, and T is thickness.


Or a very accurate formualted mathmatical equation,lol. Thanks Harold
__________________
** 1 OF 25 2005 SRT-10 Quad Cab Tremec T56
Equipped with our conversion kit.
All your Viper or Viper Truck needs in one stop. From Go Fast, To Go Low, To getting her Sexy AF!
BUILDING STREET KINGS/NOT DYNO QUEENS
https://m.facebook.com/Venomous1Racing/?ref=bookmarks
254-722-5697
Reply With Quote