Recent content by Kiwisrt10

Yea i know the rough cost. I was over 25k for my drag box conversion

Easy

Nice. I'm Ernies son. I did a manual conversion on my quad cab, now thinking of doing a forged internals rebuild and supercharging it

Kiwi srt did you used to work for fonterra?

Yes you can use 1500 ram pedal box. I just did this conversion on my quad cab srt10. All finished now

Wow that's cool. So what did you have to end up getting bro

Rear plug on the pcm is right under the join of the hood. Lots of water damage behind the plug. I removed the computer and found the #22 pin (pcm constant power)completely corroded off and snapped in the plug. I pulled the pcm apart and re soldered in a new pin on the mother board and she fired up.

I finally solved it today guys. If anyone wants to know anything electrically about there's utes I pretty much know it now. Approx 80hrs of reading thru electrical schematics

No worries Ronnie. Someone else who reads it might be able to check. It sucks cause Torrie just sent me a new tune from Unleashed turning and I can't try it out yet

Can you confirm On the Trans relay which of the 5 pins have power and earth at key off position and ignition on position??

Hi guys So for about a month my truck started playing up, not starting sometime, trans holding gears and coughing and spluttering like its starving of fuel. then all of a sudden wouldnt start at all. when i turn it to ignition and press start it cranks but no ignition. ive spent weeks looking at...

Bugger

Appox 8inches to the linner or 11inches to the hood

Still nothing yet

Hasnt come through yet