Recent content by Roz

I got one in the garage. It's from Bone's old engine. . .

HOTDAMN!!!!!!!!!! :toilet: :toilet: :toilet: :toilet:

:toilet: :burnout::driver:

I don't/wont have any major mods - but I'll have just enough. ;) Please refer to the sentence above! :toilet: You're right. Sleep tight. ;) :D I'm confused . . . How is it considered rape? :dontknow: :driver:

I'd like to put a yellow-stripe down the (lower) side of a Viper Truck! :D :D :D :D

Thank you guys!! You took, f*ckface! :D

My 06 dyno'd very well. I was extremely pleased. Mine laid down 460/495. The only mods I had were modified air-box, no-cats and bullet exhaust.It didn't even have a tune either. I think I lucked out and got ahold of factory freak! Jimi's Dyno Pull

You guys won't be disappointed! This is a fun event for an awesome cause! I've never competed, I've always watched - and it's a BLAST to watch. If I can get off Saturday (usually my busiest day too) I'll be there - watching.

They're the same, but you'll find that the TIPM (2006 only) doesn't like the lower voltage. I put some HID's in my fog-lights and the TIPM sensed the lower volted and eliminated the output signal to the fog-light circuit. I ended up putting the fog-lights on an independant switch to cure the...

That is hilarious!!! Tony's pool-boy drinkin' on the job!

Sorry bud. :o There's a couple nice ones out there!

Sold it on the Powerstroke forum . . .

SOLD!

Got it! Thanks! :) I actually got it from a friend of mine. The day I took delivery the rear seat area was almost full from the floor to the ceiling. I could bare see out the back glass and worried of shit crashing on my head if I braked too hard! Thanks! I really do like this truck a lot...

I need a vehicle inspected in Houston, TX. PM me for details! I'll make sure you're compensated for your time/travel. ;) :rock: :rock: :rock: