Recent content by staffie

Hello, I had my breech split and welded. It was at pressurization that we saw that it was split. As a result, the valve guides were out of tolerance and the machining center replaced them with new ones. They ordered them in Italy and machined to replace them all 20. As well as the intake valves...

Hello everyone, I finished reassembling the engine. It turns but I miss and I can not find. I can not find or buy the wire ties of candles. I wonder if it's not the breakdown? Aissi while I was without a vehicle, I bought a Chevrolet Tahoe to know how to work. Is there a setting on the rockers...

Hello The problem is pending. View on the forum valves I must before finishing the reassembly of the cylinder heads; Thank you all

Hello everyone, I was overflowing with work. Here then my cylinder heads rectified with new valves of admissions, new stuffing of valves. the new high-temperature special high-pressure valve seats and new custom-made valve guides because there was too much play on the intake valves. I have more...

Here is the link for the pictures. DSC_2527_zpsvlfx0g16.jpg Photo by staffie666 | Photobucket DSC_2526_zpsg3ripyph.jpg Photo by staffie666 | Photobucket DSC_2489_zpsubagly5j.jpg Photo by staffie666 | Photobucket http://i38.photobucket.com/albums/e125/staffie666/DSC_2488_zpsakemrjzj.jpg Thank you...

Also what do you think of the tips of rods of tumblers? Photobucket Photobucket And your opinion about Factorymoparparts.net? Thank you. Jp.

Hi, the rest of the works. At pressurization and after removing the valve seats, there are 2 cracks between intake valves and the spark plug. After repair at the welder. Photobucket Photobucket Now I wait for the valve guides and the pumps for the rectification of the cylinder head. To be...

Hello, I sent you 2 email on the 19/04/17 and the 10/04/17. Jean pol

Hello, I gave my breech to the rectifier. For changing the valve seats by special reinforcements for the use of LPG. He put the cylinder heads at the pressure and I have two cracks on one. At the level of the intake valve and the spark plug. So return to a welder for repair. But I'm looking for...

The push rods are round and brilliant. For oil pressure this is normal to the instrument panel. At the drain I do not have excessively filings on the drain plugs.

The oil is mobil1 0w40. I drove the vehicle with the low level. On a cylinder head, if a level is placed on the valve nose, is that they are all at the same level

Hi, I put the Mobil1 0w as on the cork. But I think I may be rolling with the low level. Nobody has a breech to make the measurement of height of the tails of souppa

Hello, the news .... In Europe it is often gas-driven (LPG) because gasoline is expensive. The problem is that this one is dry and of higher temperature which causes wear of the valve seats and the unsealing of the valve seats. The exhaust seats get tighter and the valves are depressed more in...

Hi, tell me if I'm wrong but it is often the cylinder 9 that is problematic From what I see on the forum

Hello, the piston abused. Rocker rods. What do you think? DSC_2471_zpsmrsr4awr.jpg Photo by staffie666 | Photobucket DSC_2489_zpsubagly5j.jpg Photo by staffie666 | Photobucket DSC_2488_zpsakemrjzj.jpg Photo by staffie666 | Photobucket DSC_2487_zpsnwfuyplp.jpg Photo by staffie666 | Photobucket...