I would look for a new T56 compatible shifter/knob assembly or get something on eBay. I have not been successful locating a knob that will fit on the stock shifter.
The stock shifter has rubber material separating it from the T56. I can confidently hit 3th every time upshifting under with the...
Also important, if the tip of the sensor is damaged, you will need to add a washer to the bolt for a spacer. As the engine gets older, the tolerances get looser and sensor target could start hitting the sensor and damaging it. The opposite can also happen, if the sensor is spaced to far from its...
I have had several of these fail in my five vipers/trucks.
Replacing one out is about the same amount of work as an oil change.
For some reason the Mopar sensors are not reliable.
I have had better luck the $20.00 in stock sensors from Autozone.
Due to all the failures, I always carry a...
I have used 1.5" Home Depot Ratchet Tie Downs to bend my long tube stainless headers.
Stainless is kind of soft, so if you don't have stainless, it might not work.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.