Chris@K54L
New Member
Where do I go to look at pricing for the exhaust, or even just muflfers? I can't pm, yet, so I apologize. Thanks!!
- Christopher
- Christopher
Exhaust Question
- Thread starter Chris@K54L
- Start date
mondragon-srt10
Full Access Member
I'm curious about the venomous1 snakebite exhaust pricing they sound amazing but I can never find the price so I can save it up.
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
Our Side or Rear exit SnakeBite exhaust kit is $340 shipped. $850 installed locally. Consists of muffler, X-Pipe, and side exit plates. Piping is run by us or your local exhaust shop in 3" aluminized.
Thanks for your interest,
Scott
Thanks for your interest,
Scott
So do you have a site where I can look at the products you offer?
Sorry for the thread jack but I didnt want to make another thread and I haven't received a response from my pm I sent you a while ago.
@venomous1 racing
Thank you
Sorry for the thread jack but I didnt want to make another thread and I haven't received a response from my pm I sent you a while ago.
@venomous1 racing
Thank you
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
Website isn't up yet. I'll look through my messages, I must have missed it. You can go to the vendor section of this forum and see many of our products offered.
Heres a link
Venomous1 Racing - Dodge Ram SRT-10 Forum - Viper Truck Club of America
Thanks,
Scott
LORD CHAVEZ
Full Access Member
what benefits do we get when we switch to a full 3 inch exhaust
Cudawrestler
Full Access Member
I am looking at the rear exit snakebite exhaust. Do you make a flange on the ends where it can directly bolt to the stock manifolds of aftermarket headers?
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
No flanges as the piping is run by your local exhaust shop boss. Works with headers or manifolds.
Thanks
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
You pick up hp/torque in mid to upper rpms by letting the 505ci breathe!
Our stock exhaust compares to having 1.5" pipe on a 350
Cudawrestler
Full Access Member
Gotcha. Call ya in a bit on that. Thanks
Sent from my SCH-I535 using Tapatalk
How do you run the exhaust to the drivers side? Do you cut a hole in the frame or run it under the frame?
bmxam962
Full Access Member
This is the only way to do it in my opinion
Attachments
that is just pure sex right there, awesome job man! and also correct! :rock:
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
No we DO NOT cut frame to install our exhaust. If you chose to route it that way that's on you boss.
We won't cut customers frames up for an exhaust install boss but that looks good for sure
VENOMOUS1 RACING
Has Left the Room - Banned from VTCOA!
Yessir catless for sure! With headers you're going to pick up around 30hp minus cats.
Do you have any pictures of what the exhaust setups looks like that you ship? I'm asking because I have a 3 trumpet train horn setup with a compressor under the bed where the spare tire was and want to make sure the exhaust will clear them.
Can you please post some under belly pictures of your side exhaust install?
Support Us
Become A Supporting Member Today!
