I just purchased a nos set of viper powered hood emblems my truck did not have them when I bought it. I would like to put them on as close as factory location. That being said any member would like to help and measure there's and pass that info please.
Viper powered emblem
- Thread starter Diablo
- Start date
- Joined
- May 18, 2006
- Messages
- 26,602
- Reaction score
- 3,985
Well I guess we aren't being all that helpful are we? I would go measure the Queen but she is locked in the Castle right now!
Google a pic and guestimate?
Google a pic and guestimate?
i've been known to take measurements at midnight EST for no reason...
33" to the upper left corner of the V from the corner of the hood at the front, just above the headlight where it turns towards the fender.
2 1/4" from the back of the hood scoop to the round of the R
21" from the edge of the hood at the cowl before it turns down toward the fender to the front corner of the "powered" emblem.
make sense? to be fair, i'm not measuring it again - that's a close enough triangulation there - like the one in bermuda...
33" to the upper left corner of the V from the corner of the hood at the front, just above the headlight where it turns towards the fender.
2 1/4" from the back of the hood scoop to the round of the R
21" from the edge of the hood at the cowl before it turns down toward the fender to the front corner of the "powered" emblem.
make sense? to be fair, i'm not measuring it again - that's a close enough triangulation there - like the one in bermuda...
Thanks this will help. Wont need to measure agian.
- Joined
- May 18, 2006
- Messages
- 26,602
- Reaction score
- 3,985
Hey Dan, Could we get that measurement again please to check your triangulation? LOL LOL Just kidding, chill out, it is gonna all be just fine 
Support Us
Become A Supporting Member Today!
