Wire brush the center axle flange and soak it. I use a 3 lbs brass hammer along the outer edge's of the rotor and you got to be accurate and...
you should do a smoke check to find the vacuum leak..... :)
There is a song out there with the lyrics " be kind to your knee's , you'll miss them when they are gone"
If anyone is looking for the LiveLoadDCX program to load tunes onto your SCT 9550 tuner. see attached. This file seems to have been removed from...
Although changing the shifter does help, it isn't the fix. The fix is to replace the slider keys to billet inside the trans. The factory ones are...
I had mine working, I simply followed the instructions. it was 12 year ago.... push learn button on garage door opener and then within 10 sec....
Strapping the rear O2 sensors to the frame of the truck or using spark plug anti foulers to pull the rear O2 sensor out of the exhaust stream...
High pressure is good! these truck were known to blow off the cheap oil filters, occasionally.
Careful with the valve covers! they are made of Magnesium and don't sand blast well.... they get full of holes.... I have the billy Boat headers...
Pull the oil filter. it will help to drain the lines and cooler. Still, it will be a mess job. Be patient and have a large drip pan and lots of...
No-one holds that record for long...… :(
i would check the wires to the starter. the headers may have melted them.... fix that and it should crank well. Then check the otherside behind...
To get this thread back on track..... I cut some 5/16" threaded rod into Studs . and used Nuts. Easier installation.....
Pull out the crank sensor. Maybe it was hit and is to far into the block...…
I hope you have deep pockets...... Just buy a hellcat! it will be less expensive.....
get one that is already forged......
Have the trans shop check the flex plate. they are known to crack and fail. could be where the vibration is coming from
Making boost with a supercharger takes away horsepower. especially making higher boost. Turbos are "free" horsepower....
If your 04 has both hose tee'd together, you have a large vacuum leak through the engine...... :)
I added a return spring to mine. Seemed to help, but on cold mornings, it still surges abit...... I think it is a tune thing..... AIC gets...
Separate names with a comma.
