Search results

Looking for a mint or ultra clean drivers side grille air deflector. Mine has two holes in it from an srt emblem on the grille and I’d like to change this one out.

I have full bolt ons and am running a center force. It works good. I’ve blown 2 rear ends with this clutch with street tires. If anything it’s to strong. I should have just put in a factory luk. I don’t think you can go wrong with any of those clutches you listed.

I’m trying to keep the truck original looking, if I can’t get the oem badges then I’m just going to have the shop fill in the chips and leave it. That does look good though and is an option.

Man this place is quiet now.

I can get the measurements I just can’t post to the thread. I could take pics and email them. I have an original hood and decals.

Anyone have a set of oem badges? I have some bad chips on my hood and would like to replace my set with a nos set after they paint.

Hey guys looking for nos viper powered hood decals and also looking for the nut under the shift knob in mint condition. When I took mine off I scratched it and just want to find a mint one. Thanks. my email is [email protected]

Looking for a belly pan for a 2005 in new condition or new. part number 5029611AC

Hey I have a rearend out of my truck with a set of 4.88’s with only 150 miles on them same with the posi carrier. The gears made noise when I let off the gas and couldn’t get anyone to re set-up the gears so I swapped a used 4.10 take out differential in. I have the brakes, brake lines, axles...

Should just get a set of springs from jtsvp, but reguardless you should change the sway bar end links. I used trw front sway bar endlinks from a 2008 f150 2wd. They are shorter than ours. On the back I went with a set of jmb shorter links.

Be careful with those qa1s mounted horizontal, they are twin tube and are supposed to be vertical, I’ve seen one broken on the Facebook page being used as a kicker.

Yea my truck with 18k miles on it with a few bolt-ons, would wheel hop with the stock suspension. Caltracs cures that completely. I did remove the hop shock and it didn’t seem to make a difference taking off but I noticed when I was real heavy on the brakes without it the rear felt like it was...

I ended up going with caltracs and put the kicker back in and have zero wheel hop. The new bushing is a pain to install but other than that it was simple. If your in need of a shock I bet Ridetech can make a replacement to fit, they make monotube shocks which is what we would need. Jtsvp makes a...

Smooth is what you want. I was going to do this so I ordered the smooth ones from rockauto and let’s just say I sent them back. The aftermarket quality is junk, worse than factory. Just have the factory ones sanded and filled. The All Sales (AMI) handles are billet and look real nice and would...

Sold.

Sold

Sold.

Hey do you still have the caltracs?

That's a tad over 3 hours for me, I can't guarantee I can go due to baseball (my kid is in majors) but I will try. $80 for 3 pulls sounds like a good deal.

I might be able to make it, my kid plays baseball so that trumps my plans usually.