SOLD. If the new owner joins, take care of him.
OK, all repairs have been completed and I have been driving the truck with no issues for a couple of weeks. A small crack in the head was welded...
I used the Axxess CHTO-01 to install an Alpine head unit in my truck. This wires the aftermarket radio amplifier to the trucks stock amplifiers. I...
Turns out there was still some former front cat material in the drivers side pipe blocking the rear cat. After clearing it out the truck is...
I use a Bluetooth dongle with the Torque app on my cellphone. Unfortunately I have to have the expensive one ($100+) to communicate with my JDM...
I did check the harness. Its in good condition. Did a leak down today. It was lower than I hoped but the engine was cold. They were consistent on...
Windchill near freezing today. Not that hardcore. Fuzzy slipper and fireplace mode.
Well today was a fiasco. Pulling the O2 sensor didn't help. I noticed the truck was back down to 3500 RPM and decided to pull the plugs again. The...
OK. fresh plugs and it will rev to 4200ish. Its still way down on power though it definitely is making more. I pulled the rear O2 sensor on the...
I was hoping for more but between a suspect gauge, not being able to compare numbers from other cylinders (especially from the other bank) and...
I have a separate thread for the head issues: http://www.vtcoa.com/forums/f7/crack-68710/ with pictures showing the crack and work done. I never...
I compression tested #1 at 110 PSI (cold) but then my gauge quit holding pressure. Gonna have to see if its still under warranty. I bought a fresh...
No its an 05.
Ok, pulled the plugs to do a compression test and found this. All of these were installed new with the head gaskets. All of the dark ones are from...
I can check and see if A/Z still tests coils but I kind of doubt 2 separate sets of coils are having the same issue internally. I tried taking it...
Demon coils are back in. I'm posting pics to see if I'm not reading the diagram correctly. Wires 6 and 9 seem to have the same font so I used the...
Intake gaskets don't seem to be leaking. Next I'm going pull the exhaust and see if its plugged somewhere.
I did install the crank position sensor and the TPS as they seem common issues that will not set a CEL or code. It does seem to have the same...
Looks like I need a new code reader. Fuel pressure checks out good. Double checked the O2 sensors are plugged in.
Looking to see if anyone has had this issue. I just finished installing new head gaskets and now the engine will not rev over 2500 RPM without...
Separate names with a comma.