I may try the OBX Ebay headers but wont be able to install till Aug.
I have a twin turbo 406 using OBX headers because they happen to be in stock the day I wanted to seat the motor in a car. They work great, just need to check the welds and the straightness of the flange but for the abuse they...
I made a wax cast of mine a long time ago and had the center bored out to the diameter of a monster can +2mm.
I had posted up a thread to get a billet copy made to do inserts however no one wanted in. To get the a one off made was about 2K. The billet inserts are cheap , its the cost of...
This SRT-10 has very few mods.
Aeroturbine 3" mufflers sound very deep.
Interior dealer installed red and black package.
High Flow cats from Roe Racing.
I also have a 2 DIN radio bezel that will go with the truck.
This truck will be available for view and departure mid June.
It does have a faded clear coat on the door mirrors and needs a new driver door handle bezel as someone tried to break into it with an icepick and steering wheel is peeling on the 12:00 position.
I'm selling it for $24K FIRM. It...
Does the RB1 have any aux out RCAs?
I have the standard 6 disk changer and I'm looking for a better way to hook up my Iphone without going to a single DINN.
I started out with this exact yr/color.
One thing I found was that I wanted the better performance of the ACR but in the vert. I should have bought the real ACR vert it would have been cheaper in the long run.
If it has the run flats still I'd say ditch them if you drive it hard.
Awesome car! A good set of headers with cat delete and a tune will wake it up quite a bit. I also added 3.73 gears to mine.
The headers will eliminate the xover pipe and open the exhaust up a bit so you dont have a 40deg...
If the stock appearance is desired then check out the JL 10TW3
10TW3-D4 - Car Audio - Subwoofer Drivers - TW3 - JL Audio
Req air space is .5ft^3
Mounting Depth 3.25 in / 83 mm
I've heard the 13TW5 and it was extreemly nice so the 10TW3 at lower wattage should be way better than the stocker.
I'm aware that this is an old thread, however I have a question that still might be relevent to the sub woofer replacement.
The last post mentioned dual 4 OHM voice coils.
This is normally used to acheive 2 OHM load 1/4+1/4=(1/(1/2)=2 OHM
Is a 2 OHM load the spec for the factory amp...
I'd get the Gen 2 then keep an eye out for the Roe Racing twin screw SC to go with it.
There is also a company that will build you a sheet metal intake for 4 quads on stacks.
I'm looking for about the same thing for my 32 Dodge.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.