Recent content by MacInBlack

Right on! thanks. Sounds good, but, when you say a "tad" 'bout how much is your local "tad"? Thanks for all the great ideas.

Very cool. Thanks Very helpful. Yep, plus the diameter of the rod, I think it's 14mm but I need someone to confirm that for me please. I need to know the diameter if you wouldn't mind giving me that measurement. Then I can have all four made local. Amen! Thanks everyone for...

Thanks I can get enough for one side. Thanks I'll give that a try.

Hey guyz, I pulling the GroundForce "lowering kit" off my '04 RC and going back to the stock set-up. What I need to know are the dimensions of the stock u-bolts for the rear. The dealer says there are none available anywhere and no one has any left in stock, in the US. (I find this hard to...

Ok, that make sense, thanks. Well, in that case I may trim mine a quarter inch or so. Thanks...

I really like the first one in the weeds. Did you take that picture? If so, :rock:

I hear ya on the curbs.

Saweeet! Beautiful truck. I have a black Chally kinda glad I only have one black vehicle. When you install the Caltrac's do you take any springs out of the pac's or leave the full stock pac in there?

I already did that and it help mucho. I will follow Tony's advice and pull that overload and see where that get me. There is still something not right. I don't know if the "slapper" bump stops are supposed to be in constant contact with the spring pack or not. Mine are and I just wonder if...

Well, I cut the bump stops and installed the ES button head bump stops and it made a huge difference. Thank you all for your input. I still have to sort out the rear. There's just no compliance back there. I didn't have enough time today to pull the overload springs out of the rear packs...

OUCH!!! But not unexpected....

Excellent! Consider it done.:rock:

I've had Penske's on my bikes and they are pricy. Probably cost a good bit over $2k for a set of five for the SRT-10.

Oh my. That sounds like a beautiful set up. :burnout:

Sound like the real deal. Thanks.