lbstone
Full Access Member
Just curious how some people have done this when lowering their RC's and by how much. I'm starting mine on Friday and have been doing a ton of research making sure I've got everything ready. I printed out a couple of tips in the DIY section but I haven't really seen anyone comment on how to extend these holes exactly and by how much. I was thinking of using a drill bit and just drilling out a section starting about half an inch over from where the factory hole ends. Then I was going to use a aggressive sort of dremmel bit thats about the same diameter of the hole to smooth it out a bit before shooting it with a bit of black primer. But this wont work if I only need to extend the hole by less then 3/4's of an inch. I do suspect this might be too much as I have Gary's 1"-2" drop. I'm thinking I only need to gain about half an inch which would lead me to using just the dremmel bit which I would imagine would take forever. Plus I dont want the hole to be to be to wide. I imagine trying to control a dremmel bit hooked up to an impact gun would be rather difficult and cause the hole to be all jacked up. I cant have that. Any suggestions or any other advice before me and my buddy tackle this. Thanks in advance.