Pedal very high after Viper master/slave swap

[enforcer17]

I had the Viper master/slave installed and the pedal is pretty high compared to previous setup. How can I adjust it back to stock? Do I need to shim the master cylinder? If so, where can I get the shims?

Shifting certainly seems a lot better, can finally shift from second to third at WOT. Even coming off the line normally, the clutch feels like it engages more smoothly.

 

[JTS VENOM PERFORMANCE]

I had the Viper master/slave installed and the pedal is pretty high compared to previous setup. How can I adjust it back to stock? Do I need to shim the master cylinder? If so, where can I get the shims?

Shifting certainly seems a lot better, can finally shift from second to third at WOT. Even coming off the line normally, the clutch feels like it engages more smoothly.

either get some washers and shim out the master cylinder from the firewall up to i think 1/2 inch ,

or you can get shims from justin at JMB I do believe.

but either way it will still be a touch higher than oem will be

 

[enforcer17]

Thanks, I bought this from Justin so I just sent him a note.

 

[FATJACK]

Makes a BIG difference doesn't it.:rock: :rock: :rock: :rock: :rock: