T56 1k miles, dyno only

[N/A86]

Hello, i have a ram10 t56 i purchased for my camaro not knowing the extent of what i would need to change. It has the bell housing, origonal hurst shifter, origonal throwout bearing and the yoke.. i bought it from a machanic at a gm testing shop outside detroit. He got it from another machanic there that had previously worked for a similar crysler/ dodge testing shop it was used to break in engines so it has hardly any miles. $2800 i can get pics and #s soon, thanks. Adam

 

[Yellow venom]

Do you now if this Tranny came out of the car or is it from a truck? ( there's a difference in the two)

 

[6speedquadcab]

Do you now if this Tranny came out of the car or is it from a truck? ( there's a difference in the two)

He mentioned Ram10 so I am assuming a Ram SRT-10.

 

[earl lee]

Wouldnt this be a good buy for one of you QC guys who want to switch over? How much do our T56's go for anyway?

 

[VPRPWRD]

Wouldnt this be a good buy for one of you QC guys who want to switch over? How much do our T56's go for anyway?

For the miles on the transmission I feel his price is in line.

 

[VENOMOUS1 RACING]

Hello, i have a ram10 t56 i purchased for my camaro not knowing the extent of what i would need to change. It has the bell housing, origonal hurst shifter, origonal throwout bearing and the yoke.. i bought it from a machanic at a gm testing shop outside detroit. He got it from another machanic there that had previously worked for a similar crysler/ dodge testing shop it was used to break in engines so it has hardly any miles. $2800 i can get pics and #s soon, thanks. Adam

And please measure size of yoke barrel for output shaft:burnout:

 

[6speedquadcab]

PM sent.

 

[N/A86]

yes its for the truck, as for the yoke its pretty big... also i didnt mention i took the input shaft out planning to swap to an fbody shaft, ill put it back together but if ud like i can take some pics of the guts before the mid plate goes back on.. and i was told by somone at liberty gear that there are 2 diffrent input shafts, one with 29 teeth? and one with 31 teeth, this is the 31 tooth gear

 

[BulldogSRT]

If 6Speed didn't already beat me to it, let me know. I might still be interested. I've only had this thing for a couple months, and the manual conversion's at the top of my list

 

[caveman]

I've only had this thing for a couple months

Welcome to the VTCoA.

 

[N/A86]

Still forsale for now

 

[N/A86]

If 6Speed didn't already beat me to it, let me know. I might still be interested. I've only had this thing for a couple months, and the manual conversion's at the top of my list

Its yours if you want it

 

[N/A86]

Finaly took some pics

 

[N/A86]

morepics

 

[N/A86]

picsagain

 

[N/A86]

moreee

 

[N/A86]

last of the trans pics

 

[N/A86]

TB and yoke... and done

 

[Funkybunch]

TB and yoke... and done

I might be interested if it is not sold yet. I need to check with Scott about what is needed to finish up the conversion on my side.

Mark

 

[VENOMOUS1 RACING]

TB and yoke... and done

Can you measure yoke barrel with a caliper please. Still hard to tell but looks small. Looks closer to 1.66" than 1.885"