RagunCajun
Full Access Member
Anyone with a spec 3+ clutch? How many and what kind of shims did you use? That goes for other aftermarket clutches too. Please describe drive ability how it felt before and after too.
There are a couple ways of doing this but remember, all clutch manufacturers design the clutch/pressure plate around the FACTORY SLAVE!! If you run a Viper Coupe hydraulic setup you have to shim period. Regardless of clutch! It all boils down to the slave used.:burnout:
Before u go crazy, try a new master first..when I put my new tranny in my slave was fucked up. patience grasshopper
I apologize for not updating.Thread update ? What did you end up doing?
I am clutch shopping and prefer the spec stage3+ . Was wondering about slave spacing as well. Thanks.