Bad RC had this cool mod we just had to share with you guys, I went a lil while ago and bought all the stuff to do it, total cost about $35:rock: and that was with stainless hardware!
Now It only took about 10 minutes to do!
Looks great and may actually add a little bit of protection to the front fascia.
Now mind you , it is only foam, so the protection isnt going to keep the front fascia from actuall damage , but while at lowes I did see a couple furniture floor savers that you could add to maybe give a little more protection.
but all that was done was to lay out the door edge across the front bottom of the fascia.
dont cut it until you are done, and dont pull it tight across, jsut let it lay naturally.
now I got stainless self tapping screws, and stainless washers to do this with..
I dont think instructions will be needed, it is pretty self explaining
and with Bad RC's blessing I may add this to the site, and you know I have to make a dollar or two, but it will be offered with his ok
[/IMG]
[/IMG]
[/IMG]
[/IMG]
Now It only took about 10 minutes to do!
Looks great and may actually add a little bit of protection to the front fascia.
Now mind you , it is only foam, so the protection isnt going to keep the front fascia from actuall damage , but while at lowes I did see a couple furniture floor savers that you could add to maybe give a little more protection.
but all that was done was to lay out the door edge across the front bottom of the fascia.
dont cut it until you are done, and dont pull it tight across, jsut let it lay naturally.
now I got stainless self tapping screws, and stainless washers to do this with..
I dont think instructions will be needed, it is pretty self explaining
and with Bad RC's blessing I may add this to the site, and you know I have to make a dollar or two, but it will be offered with his ok
