Recent content by scott775pd

Thought I needed to replace the master and found that the diaphragm had sucked itself to the bottom and sides of the resovior so tightly that it wouldnt allow fluid to pass down the line. No leaks or any indication that it was low on fluid. Never seen this before, but pulled out the diaphragm...

Nice to have this forum to discuss these things - put alot of arm into it and it did move back some, and reduced the wobble, but still sticking out about 2 ribs worth on the belt - dont want to over do it, but still had the tension on the pulley - not sure how much more to torque on it for fears...

clutch master cylinder After examining the master - it turned out to be the diaphragm. the diaphragm sucked itself to the bottom and the sides of the resovior so tightly that it wouldnt allow fluid to pass down the line. Almost tore it trying to release it from the sides, but got it out - bled...

Great info - thanks man. Will update after new master is in

13/16 bolt - thanks for the help - hopefully no crank end damage

PM sent to Justin - thanks for the info

not only did I join the crank pulley wobble club - went to shift from 1-2 pedal went to floor - new master on the way. 04 rc 32,000 mi any tips on bleeding after the new one is in?

Any idea on the torque spec? I dont want to break anything - but how much arm?

loose crank pulley bolt Couldnt figure out why I was chewing up serpentine belts - after reading this post I went to take a closer look - could turn the bolt by hand - pulley is sticking out 1/2 inch further than the others and is wobbling - hopefully there is no damage. Tightened it up best I...

hydraulic failure Stepped on the clutch pedal to shift into 2nd and down to the floor it stayed? Are there any known problems with these master or slave cylinders? Hoping its just a cylinder and nothing internal in the clutch. If I pump the pedal 8 or 10 times I can get it to work, but...

Just bought an 04 RC. It has a cat back and a cold air. Just wondering which headers and chip to buy. Any input would be appreciated.