Recent content by Srt10650

Any pictures of the valve covers and how much? Thanks.

Like mentioned already, tow the truck home but definitely don’t drive it. Plugs might be able to tell you something of what’s going on inside the engine. On the receipt from the dealer, was there any other notes or cel?

Like already mentioned, any codes? How are your spark plugs and wires? How many miles?

Info on your engine?

I replaced mine with this one, comes with new pump and new o ring. You have to swap out your reservoir tank and pulley. Other than that it’s good to go.

Yes, especially when the engine was getting up to temps.

Also since the truck was down, decided to replace my power steering pump. It’s been going out for a while now, just haven’t had time.

A couple of pictures of them installed. Decided to also replace my spark plugs since I had more room due to the valve covers being removed. They turned out pretty good.

The originals go bad after time because of some many heat cycles they go through.

How many miles on your truck? When was the last time you serviced your transmission? Could also be your calipers sticking.

I stripped them from the rattle can paint, went with my local powder coat shop. Price was pretty cheap($100.00) for both, turn around was about a week and a half. Went with wrinkle black to pay homage to the 426 hemi wrinkle black valve covers. Turned out pretty good. Also got new valve cover...

Decided to do some cosmetic upgrade while my truck is still on non op before I bring her back to the streets. Red paint on the valve covers had seen better day and decides to do a wrinkle black rattle can about 7 years ago. That was good for a while until they started to peel too. Below are some...

I got these a few years back, I think for like $80 or $100 for all 4 on either Craigslist or offer up. Not bad for the price and looks pretty good.

Has anyone tried any of these pumps and had luck?

I had 20s on back in the days, ride was good. Here’s my truck with 20s and 2/5 drop.