Recent content by Thomas J

You in Beaufort area? Saw one on Sam's Point Road the other day.

I think mine are 5/8"

Can I attach w/o pulling intake?

Damn...How far under intake?

PVC :D Might even finish one day

PCV Getting there

Is the hose coming from the drivers side valve cover the PVC?...Where does this hose run to? Had the intake off and now lost as to where it runs!:dontknow:

Thanks JTSVP.:rock:

So does this look like it's assembled properly? Lost the dang paperwork. Anything else need to be done or adjusted after fins are installed and it's mounted? Also had one small, thin washer that I put on the shaft under the spring. My next project I'll take pictures so I can remember how to put...

So, lesson still not learned to mark parts or take pictures. I need to figure where it all goes back now. Upper water pump to lower connection at firewall? Lower water pump to upper connection of (heater pump?) where oil lines attach. Upper connection on large fluid tank to top of small water...

Found it.

Moving back to Parris Island next month. Add me to the SC list!

Awesome help! Thanks! Now...is the cylinder order right front to left 1-2 and the remaining right to left 3-4, 5-6, 7-8, 9-10?

Thanks!

Anybody got a good picture of the coils and wires attached with intake removed. Want to see how the factory setup looked/routed. Thanks.