Recent Activity

Srt10650 replied to the thread Stock 2006 front and rear suspension needed.

Where you able to get the parts? If not, I have my parts off my 05 QC. I have front springs, rear shackles and u bolts with plates. They...

Scotty_R8 replied to the thread Possible PCV issue?.

I may have worded that incorrectly. The initial sound was from the elbow's and had a vacuum sound. after fixing that, the second sound...

Scotty_R8 replied to the thread Possible PCV issue?.

Thanks for that. So where does the larger one on the front left of the TB connect to?

Scotty_R8 liked Slitherbeast's post in the thread Possible PCV issue?.

Vacuum is hosed from the intake manifold from behind the throttle body underneath to the driver side valve cover. (Some of us install a...

CaptnCrash replied to the thread Possible PCV issue?.

On the '04 both valve covers are T'd together and run to a port just aft of the throttle body. On mine I just plugged the port and ran...

Slitherbeast liked 68charger's post in the thread BBK throttle body hanging at high idle..

my bbk did this as well, i ended up taking the blades out and lightly sanded them by hand then when i put them back in i centered them...

Slitherbeast replied to the thread Possible PCV issue?.

Vacuum is hosed from the intake manifold from behind the throttle body underneath to the driver side valve cover. (Some of us install a...

Scotty_R8 replied to the thread Possible PCV issue?.

Thanks for the info, i'll give it a look. Also to add, I believe the two lines coming from each valve cover was T'd underneath and had...

Scotty_R8 liked Ram x 10's post in the thread Possible PCV issue?.

It does sound like it could be excessive crankcase pressure. First inspect that the hoses from both valve covers are routed correctly...

Slitherbeast liked Ram x 10's post in the thread Possible PCV issue?.

It does sound like it could be excessive crankcase pressure. First inspect that the hoses from both valve covers are routed correctly...

Ram x 10 replied to the thread Possible PCV issue?.

It does sound like it could be excessive crankcase pressure. First inspect that the hoses from both valve covers are routed correctly...

Scotty_R8 replied to the thread Possible PCV issue?.

To add to all of this, there were two other guys helping when everything was pulled apart and then two weeks went by before putting it...

mikeH liked ckjarr's post in the thread Tennessee (8).

I’m still in North West TN!

Scotty_R8 posted a new thread.

Possible PCV issue?

So I purchased my 04 RC earlier this year and it was obviously not treated correctly in the past. It seemed a bit sluggish IMO and over...

Forum: General Discussion

Jumpingjoe628 replied to the thread Pinion angle shimming.

Thanks but I've already got that all figured out. Just make sure to use bushings for the rear links cause otherwise the metal to metal...