Search results

Dont worry it was on a closed section of street lined with hondas and nissans...jkkk. But in all fairness im usually mr. lets go to the track preacher, but when there is someone that just needs to be put in there place well....

I love my Bassani headers in my truck!

Looks awesome! Black is so hard to clean, silver always looks clean haha

I want your motor and turbo setup hahah

Awesome if it stays running :p

Well after I replaced all the fuses, hit the go button and started right up... let it run for 10 seconds, turned it off.. checked everything, all good. Tried restarting and it took a bit due to all the fuel being in the cylinders but started and ran... let it get to operating temp and it sounds...

haha you would be that guy to rub it in :p

grrrr lol.... well at least i dont have any trouble codes lol

how come when i put the relay back in the fuse didnt blow?!

the dealer i sold the truck to is almost 3hrs away haha

MAJOR UPDATE ha:: Went outside and pulled the o2 relay and the fuse didnt pop... put the o2 relay back in and the fuse didnt pop... did the key sequence and it now worked and said done in the odo so the computer is back up and reading.... I dont have enough fuses right now to complete the...

sounds good! I will try that

That is why i would assume it would blow that fuse to... but at this point i guess anything is possible. Its going to be an all day venture tomorrow checking wires

I like when they have their gf's in the car with them. They usually only do races that they know they can win.. too bad its not just a ram 1500 ;)

Mental check on wires to check:: 1. o2 wires 2. injector wires 3. coil wires 4. ecm wires I believe that is everything that runs on that circut

Would fuse 49 (o2 sensor fuse) blow if it was an o2 issue? I know that its inline with the ecm/asd fuse

I have to pick up some more 30a fuses to test if the sims blow the fuse, i bought all that one of the local auto stores had in stock :p

grrrr what a headach ha.... I just want to drive my new truck :(

just went over as many wires as i could and visually they all look good :/ none are by a heat source or anything. I guess my next step is pulling the o2 sims, This is what I dont get though. If the ecm is not plugged in, then the fuse does not blow. Once the ecm is plugged in it blows. Even if...

hahaha! Did you have to replace the whole harness?