Search results

410 with 02 syms

you can use your ecm i have sitting here instead.:dontknow:

we have them for $468:D

one of the biggest advantages in going with a Striker is the new placement of the valves. they are relocated to improve flow from showding. not to mention improved coolant flow and better clamping surface, and improved runner shapes and radius'. we have had a set of fully ported heads on a flow...

with our 4 bearing internals for the shaft, and since the blade design doesnt rub, can cause this becuase of the lack of friction. as your linkage takes a set on the set screw pin, this effect will lessen.

you can also just ever slighty back of the adjustment screw on the TB that the linkage cam rest against. but give your truck 200 miles before touching this.

since you have a QC, the computer wont let the engine get down below 1000 to avoid lugging and bucking the engine, so yes its correct in drive the ecm wont let it go below 1000 rpm when cruising.

A man was riding his motorcycle along a California beach when suddenly the sky clouded above his head and, in a booming voice, the Lord said, "Because you have TRIED to be faithful to me in all ways, I will grant you one wish." The biker pulled over and said, "Build a bridge to Hawaii so...

make sure you open the bleeder on top of the t-stat housing, and do it with the radiator cap off, the truck running, and the heater set to hot and full blast. do this until i quits burping air, you may do it several times to get most of the air out

very cool, thanks for the post. enjoy, and btw, we make no claims against unusual rear tire wear as a result of installing our throttle body!:D :rock:

dont use off the shelf stainless, they are soft, and will stretch from the load and heat. the easiest thing for you to do , is get grade 8 bolts, and use 2 nuts per bolt. tighten the first one, then tighten the second one against it, and jam them together make sure you have a washer under the...

read the instructions, look at the pics, call with any questions:burnout:

thank you Kevan, you are a first class friend. nats+Kevan=good time:D

if you have one of our later shifters with the Jedi lever, it should have composite washers that go between the shift arm, and the shifter base's arm, and composite washers under the steel washers for the bottom 2 bolts. so it goes: bolt, steel washer, composite washer, then lever, composite...

fffffffffffffffffffffire!!:D

hey i remember that! my skin is now growing back on my fingers!

the lift and tools are here for you to use!

you and Beeotch!:rock: :D

pretty phuggin slim, since i am a road racer not a drag racer. if you werent an AUTO sissy, i'd have you drive my truck;) :D JK, bub.. Justin makes less power than my or stink/flamerboy, but he can drive a stick. but ol, flamer/stinkey is getting good too.

keep smacking them gums, flamer!:D you will at least LOOK fast when i get done with you. and dont be calling Kevin about messing with the boost controller! shit i might even haul Kevin up there and drive for me!;) :D