I am back about swapping to the auto trans in the 04. MSD has a pulley mounted crank trigger kit, but it is for an even fire engine[5 magnets for 10 cylinders]
Any chance I could use 2 plates and couple them 18' offset, for 10 magnets odd fire? Would one pickup sensor be able to read all 10 magnets with the 5-6mm offset?
This way we could just use the readily available QC flexplate without needing a special one built.
Open to suggestions?
Any chance I could use 2 plates and couple them 18' offset, for 10 magnets odd fire? Would one pickup sensor be able to read all 10 magnets with the 5-6mm offset?
This way we could just use the readily available QC flexplate without needing a special one built.
Open to suggestions?