moparracing said:does anyone have a link to where i can get 1/2" steel lowering blocks ?
i found aluminum one's, but would prefer steel......
http://store.summitracing.com/partd...t=AFC-20244&N=700+4294845462+115&autoview=sku
help is much appreciated.
he said he didn't have anything nor did steve (texas yellow fever)........Nowwhat said:
mike,Nowwhat said:well then....
http://www.djmsuspension.com/Products/Tech/AllSteelBlocks.htm
just trying our vendors 1st...
moparracing said:mike,
appreciate your efforts !!! unfortunately, they only go as small as 1".......
does anyone have an old slapper bar & stock king pin left over from a caltrac install that they'd give me ?? i'd pay for shipping....... i could make my own 1/2" lower block out of those parts......
thanks.
ever since i put the caltracs on, my truck sits a 1/2" low on the driver's side.... currently, to get it level, i have the driver's side caltrac jacked up a bunch & little or nothing on the pass side.... i want a 1/2" steel lowering block for the pass side to level it out so i can then set my caltracs properly.......Prof said:
