2008 VIPER CLUTCH UPGRADE

[STUDBOYZ]

ANYBODY TRY THIS YET?
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=370169170339

 

[FATJACK]

That is a hell of a deal....

 

[TREKER]

Will it fit our trucks and are the hydraulics right?

 

[Ram From Hell]

I'd think that it would fit, but you still need the shims that make the Viper hydraulics work on the truck.

 

[LitemUp]

You're gonna need the master which is not included in this package with the spacer. Not sure that the flywheel will work on our trucks though. It might be too light.

 

[JTS VENOM PERFORMANCE]

i dont think it works , but Dragon was working on this , you may need to contact Dragon to see if it does, he contacted me about an input shaft and I didnt have one.

 

[ARRESTmeRed04]

i dont think it works , but Dragon was working on this , you may need to contact Dragon to see if it does, he contacted me about an input shaft and I didnt have one.

yeah i think our input shafts are 31 spline and the new twin disc setup is 26

here is the link to the thread
http://vtcoa.com/forums/showthread.php?t=30032

 

[dragon]

here is the low down on the dual disc set up from mopar. p5155122 converts a 2005-2006 viper to a 2008 dual disc clutch. requires p5155123 6 speed transmission kit, not compatible on vipers wiht a flywheel crank trigger.

p5155122 is the dual disc set up.
p5155123 is a 6 speed trans from a 2008 viper.

i found that the input shafts are diffrent between the 04-06 viper to the 08-09 viper. i did not get any further then the input shaft but it has a diffrent spline count. 26 compared to 31 if i remember correctly.

i dont believe this set up will work wihtout the new viper trans. just to let you know the new viper trans is around 3500.00. hope this helps.

 

[mr. anderson]

isn't the new tranny supposed to be beefed up also?

 

[pokeytemplar]

Yes the new tranny is beefed up......

 

[JMB Justin]

Also the flywheel does not have the crank trigger pickups on it. Im supposed to find out today on the spline count and if the pressure plate will bolt to our stock flywheels.
Justin

 

[STUDBOYZ]

I have the centerforce/viper slave combo now but it was looking a little worn when i pulled the motor, saw this on ebay and thought what the hell.
I'll just get a new centerforce and be done with it, that is a killer deal on a clutch though..