Aftermarket sub install question

Discussion in 'General Discussion' started by reid06, Sep 15, 2011.

Car Parts
  1. reid06

    reid06 New Member

    Messages:
    34
    Likes Received:
    0
    Joined:
    Jul 20, 2011
    Location:
    Gulf Shores, AL
    Well my subs and box are installed. I pulled the dash and I'm trying to figure out which wires went to my stock sub? I'm running my stock head unit, so I'm using a stepdown converter. I don't want to tie into a door speaker or run a trial and error marathon till I figure it out. Any help would be greatly appreciated.
     
  2. amtrucker22

    amtrucker22 Active Member Supporting Member

    Messages:
    5,767
    Likes Received:
    5
    Joined:
    Mar 26, 2007
    Location:
    Pensacola, FL
    I misunderstood you on the phone. I thought you were trying to get the head unit out.

    There is a stock sub amp that moparracing tapped in to at this LINK

    Are you going to run an aftermarket amp? You might want to run a LOC (line out converter) from the head unit to the amp so you can get RCA's to it.
     
  3. luvsrt

    luvsrt Full Access Member

    Messages:
    116
    Likes Received:
    0
    Joined:
    Apr 4, 2007
    Replace the deck, they are cheap. Use a PAC converter to feed signal to factory amp for all but the sub. RCA direct to your sub amp. It will sound waaayyyyyy better for about $200
     
  4. moparracing

    moparracing Full Access Member

    Messages:
    5,809
    Likes Received:
    0
    Joined:
    Jun 8, 2006
    Location:
    battle ground, washington