Any suggestions

[stick]

I will be taking off my intake tommorrow to install my plug wires. Any thing I should know before I start? I bought these wires from Justin and was wondering if I have to smash them with pliers to make them "clamp" on the plug? Also I heard some of yall say that they dont fit into the stock wire holders, What did yall do to make them fit

 

[ViperTruck2933]

I will be taking off my intake tommorrow to install my plug wires. Any thing I should know before I start? I bought these wires from Justin and was wondering if I have to smash them with pliers to make them "clamp" on the plug? Also I heard some of yall say that they dont fit into the stock wire holders, What did yall do to make them fit

Take a drill and drill out the stock wire holders a little bit and they'll fit. :rock:

 

[Texas Yellow Fever]

You should not have to smash them or do anything, in fact you should put some grease in the boots so you can get them off to change the plug wires. Someone actually drilled out the factory seperators and made them work, you could try that. I just used the seperators that came with the wires and a couple of wire ties here and there...other than that and a case or two of beer, I can't think of anything...

I'm actually working on some billet seperators too...

 

[JTS VENOM PERFORMANCE]

ducktape:rock: monkey wrench:rock: 2 six packs

 

[Brat]

ducktape:rock: monkey wrench:rock: 2 six packs

you forgot the sheep.

 

[Silverback]

ducktape:rock: monkey wrench:rock: 2 six packs

So, that's where my wrench went.

 

[JTS VENOM PERFORMANCE]

So, that's where my wrench went.

da sheep ate it

 

[ViperTruck2933]

You should not have to smash them or do anything, in fact you should put some grease in the boots so you can get them off to change the plug wires. Someone actually drilled out the factory seperators and made them work, you could try that. I just used the seperators that came with the wires and a couple of wire ties here and there...other than that and a case or two of beer, I can't think of anything...

I'm actually working on some billet seperators too...

PBJ drilled mine and they fit great now.:rock:

 

[ViperTruck2933]

Here's a couple pics of the MSDs with the holders drilled out.

 

[mauiSRT/10]

Nice engine pics Tim!!! Very clean!


patrick

 

[Silverback]

Here's a couple pics of the MSDs with the holders drilled out.

Headers. I like headers.:rock: