Any1 knows how to replace the clutch?

[boomsrt10]

Hi,

Can any1 give me the instructions on how 2 replace my clutch, slave and
master cylinder?

 

[Ironhead]

ya take the old one out and install the new one ya i know could not resist the temptation ok im going back into the basement bye!

 

[JRSVIPR]

ya take the old one out and install the new one ya i know could not resist the temptation ok im going back into the basement bye!

Old Ironhead is quite the kidder, What he was trying to say was, For a small donation we have a great DIY section.

 

[boomsrt10]

Lol..

No serious..

Whats da order..

Do i need 2 remove stick shift and drive shaft plus trans.. wat else??

 

[BigRed460]

thats it then comes pressure plate, the your flywheel. Leave the bell housing on the tranny. You need a pilot bearing puller, and something to disconnect the hydraulic lines(needle nose), and a alignment tool(i have and old input shaft that works way better than the plastic one). Pritty straight forward, about 2 hours to change everything with a tranny jack and a lift...

 

[boomsrt10]

I am a supporting member