Eric_Pllcc
New Member
Disappointing Baseline Dyno
Did a baseline dyno on a Mustang Dynamometer at 92 degrees outside, 4th gear pull, K&N drop in filter and a welded on flowmaster axle-back exhaust (bought the truck used, don't know what else was done), and no tune. Made 383 HP and 391 TQ. When the guy was putting the load for the vehicle, he thought the load was too low for the truck (2.2) and switched it to a Ram 1500 V8 (believe it was 17). I'm a little disappointed in the numbers. The guy also said I'm a little rich.
Did a baseline dyno on a Mustang Dynamometer at 92 degrees outside, 4th gear pull, K&N drop in filter and a welded on flowmaster axle-back exhaust (bought the truck used, don't know what else was done), and no tune. Made 383 HP and 391 TQ. When the guy was putting the load for the vehicle, he thought the load was too low for the truck (2.2) and switched it to a Ram 1500 V8 (believe it was 17). I'm a little disappointed in the numbers. The guy also said I'm a little rich.
Attachments
Last edited: