2005ViperRam
Well-Known Member
- Joined
- Oct 13, 2012
- Messages
- 224
- Reaction score
- 432
When rebuilding your front calipers, would you reuse your pistons? If not, why not?
The reason I ask is Mopar 05143399aa are about $30 each, as long as you don’t go to the dealer. When you need 8 for two calipers that add to a bunch of money!
It seem like if they are not cracked, they would be good to go. I understand the rubber seal and ring needs to be replaced, but that hard ceramic piston doesn’t seem like it would go bad. Just curious what others have to say.
Luckily, the seals and rings are very cheap. Just use Dorman D352885.
I must say, putting on those new seals is like being uncircumcised. After you put it in the slit, you need to roll the foreskin back to make sure you’re fitting inside the slit opening
properly.
My truck is so sexual!
The reason I ask is Mopar 05143399aa are about $30 each, as long as you don’t go to the dealer. When you need 8 for two calipers that add to a bunch of money!
It seem like if they are not cracked, they would be good to go. I understand the rubber seal and ring needs to be replaced, but that hard ceramic piston doesn’t seem like it would go bad. Just curious what others have to say.
Luckily, the seals and rings are very cheap. Just use Dorman D352885.
I must say, putting on those new seals is like being uncircumcised. After you put it in the slit, you need to roll the foreskin back to make sure you’re fitting inside the slit opening
properly.
My truck is so sexual!
Last edited: