Comp Cams info

bucke77 said:
did you upgrade your valve springs. i have been told with that lift of cam you gonna want to. if so, what springs did you use. are your rockers still stock?

Still running stock valve springs. This cam isnt that agressive in regards to lift and the senior engineer at Indy reported no need to upgrade the stock springs.
 
Bump for lethal Hemi check out the first page has a dyno sheet of the cam your asking bout

Thanks so that cam is good for about 25 rwhp and 14 ftlbs. Is that the average gain on a SRT10 with LT headers. iirc i could read somewhere were people had said cam on these motors can gain up to 50rwhp easily
 
Thanks so that cam is good for about 25 rwhp and 14 ftlbs. Is that the average gain on a SRT10 with LT headers. iirc i could read somewhere were people had said cam on these motors can gain up to 50rwhp easily

Midnight picked up close to 50rwhp with his cam swap and the cam he installed was not that aggressive. Roe advertises big gains with their cam too. The Crower grinds appear to be the most torque focused (based on my own very limited opinion regarding cam specs).

Or your buddy could just BUY EXACTLY WHAT GG RECOMMENDS!
 
Thanks so that cam is good for about 25 rwhp and 14 ftlbs. Is that the average gain on a SRT10 with LT headers. iirc i could read somewhere were people had said cam on these motors can gain up to 50rwhp easily

MMMtorque picked up about 50rwhp corrected. His last dyno was at 3000DA compared to his original dyno at a much better DA. His truck was pretty F'n sick.
 
Before the cam 455 rwhp and 504 rwtq.
After the cam 520 rwhp and 545 rwtq.
65 more HP and 41 more TQ.:D
 
I have a custom can from JTSVP. I do have a sound vid but I don't know how to put it on the forum. pm me your # if you want and i'll be happy to text it to you.
 

Latest posts

Support Us

Become A Supporting Member Today!

Click Here For Details

Back
Top