Crank Pins

[McLuvin]

Anyone who might have the paxton crank pinning fixture, could you let me know how far apart the two center holes are? I wanna make a jig to pin mine. Thanks in advance!!

 

[yellowfever#154]

http://www.roeracing.com/ProductCart/pc/viewCategories.asp?idCategory=262 If you are slightly off with your measurements it could cause a major headache. I would just buy this from Sean, or better yet find someone who has one and doesnt need it anymore, like myself. When you drill the holes half of it is in the balancer and the other half is in the crank, Seans jig makes it bang on and straight.

 

[ZCx]

i would vote for that plan:rock: :rock: :rock:







oh wait, i just did, lol:rock: :rock: :rock: :rock: :rock: :rock: :rock:

 

[McLuvin]

wanna sell it?

 

[1qksrt]

Anyone who might have the paxton crank pinning fixture, could you let me know how far apart the two center holes are? I wanna make a jig to pin mine. Thanks in advance!!

My measurements put it at 1-1/8inch(1.125)center to center.

 

[yellowfever#154]

wanna sell it?

I would love to but problem is I cant find it, I musta gave it away when I sold the Roe. Someone on here will have one for you.

 

[fastbill]

sent you a PM McLuvin.....

 

[Yellow venom]

I would love to but problem is I cant find it, I musta gave it away when I sold the Roe. Someone on here will have one for you.

I don't have it,LOL

 

[McLuvin]

Thanks for all the help fellas, I'm borrowing one. It's probably safer than trying to make a jig.. Did I say probably?