deleate cats

[stick]

So if a person was the gut the front cats, they would need oxygen sensor simulators, correct? Now that we've discovered its a gain to do so. . .

or get some spark plug non foulers and drill one out, put the one thats not drilled out in youre exaust and then screw the drilled out one into the one thats not drilled out, then screw youre sensor in. that will make it for no codes are thrown

 

[mauiSRT/10]

or get some spark plug non foulers and drill one out, put the one thats not drilled out in youre exaust and then screw the drilled out one into the one thats not drilled out, then screw youre sensor in. that will make it for no codes are thrown

What you have just described kinda sounds like the same concept as the sims I posted in my pic. They are hollow with a small hole on the end that screws into the pipe. You then plug the sensor into the other end. I bet they are basically the same thing.


patrick

 

[sleeper]

I don't have my truck right now, but how hard is it to swith midpipes, is it something you can do quick before you go to the track?

Not hard, but I'd say not very fun either on your back under there getting shit in your eyes. The best thing to do is weld on flanges to both the stock pipes and the off road mids. Then it wouldn't be so bad doing the swap.

 

[Roz]

What you have just described kinda sounds like the same concept as the sims I posted in my pic. They are hollow with a small hole on the end that screws into the pipe. You then plug the sensor into the other end. I bet they are basically the same thing.


patrick

Where's the pic?

 

[moparracing]

So if a person was the gut the front cats, they would need oxygen sensor simulators, correct? Now that we've discovered its a gain to do so. . .

yes, for the back two sensors - either electrical or mechanical..... not needed if you get your pcm reflashed, they eliminate the check engine light issue.....

 

[moparracing]

What you have just described kinda sounds like the same concept as the sims I posted in my pic. They are hollow with a small hole on the end that screws into the pipe. You then plug the sensor into the other end. I bet they are basically the same thing.


patrick

correct.

 

[mauiSRT/10]

Where's the pic?

This pic was earlier in the thread.


patrick

 

[Sharpimage]

I've searched the fourms and to my suprise there is no video that does these
mid cat deletes justice. Does anyone have a better vid they can post of
there truck with the cat delete pipes and a magnaflow?

Sharpi

 

[mauiSRT/10]

Sorry I do not have vid or sound clips unless you want me to try with my cell phone.......not sure if that format will even work.

After driving over 100 miles this weekend my thoughts are.........its definatly louder in the cab. You hear it all the time.....especially at low rpms through parking lots etc........if you dont like the droning sound of an exhaust, dont do this mod. At WOT its just loud, but I felt mine was loud before at WOT too.

patrick