djm lower control arm drop

[bmxam962]

Was wondering if any one is running djm's drop lower control arm? They offer a 2&3 version uses stock springs. Thanks for your input

 

[Dom426]

yep!!

 

[ARRESTmeRed04]

Just put some 2" on last week, fit great. Dropping the truck off to get aligned today. I'll post pictures when I get home

 

[madmanadam]

yep, got them on. :rock:

I went and had it aligned this weekend and they could not get to spec.
drives straight and no pulling.
Used the specs form the manual.

 

[bmxam962]

I was thinking about using the 3 inch drop ones would that be to much?

 

[madmanadam]

I'm front lip is 6.25 off the ground. 2/3 drop. I do bottom out when I hit a pot hole. Hits the fender liner. soften the shocks and no more hitting.

 

[caveman]

How much do these weigh compared to the stock arms?

 

[ARRESTmeRed04]

How much do these weigh compared to the stock arms?

A little lighter than stock. Madman, how much clearance do you have from you axle tube to frame rail with the 3" block

 

[NSDQ]

Did any of you lower the rear end? Will there complete drop kits work on our trucks?

 

[SRT2SLOW]

Did any of you lower the rear end? Will there complete drop kits work on our trucks?

No. Just the front. You will need an axle flip kit for the rear Sir

 

[NSDQ]

Ah gotcha. And what did I say about calling me sir? lol

 

[madmanadam]

how much clearance do you have from you axle tube to frame rail with the 3" block

will take a look.

Did any of you lower the rear end?

3" blocks in back.

 

[NSDQ]

Where did you get the 3" drop for the rear? That's about as low as I'd like to go in the back.

 

[rare03srt10]

Where did you get the 3" drop for the rear? That's about as low as I'd like to go in the back.

You can get blocks for the rear anywhere SIR(sorry had to do it). I think Tony sells some billet ones or you can just go to your local autoparts store and pick some up for a 1/4 of the price lol

 

[NSDQ]

hahaha smartass. But I'll check out some parts stores. Thanks.