Front bumper cover

[94rt10ohio]

Other than the obvious exposed fasteners and screws is there anything (hiding) that is holding the front bumper cover on? Maybe behind the black grill mesh? I am going to pull mine off while I have it out of action doing the exhasut to repaint it. I really hate stone chips!

 

[2ndchance]

Good question, only one way to find out....... ripp that sucker off.

 

[Kevan]

Using a grease pencil (or masking tape and a Sharpie), mark where the current cover is set. Or you can just measure the gap(s) and write 'em down. This will help with alignment when re-installing.

It sounds like you have the belly pan screws and the 3 screws from each wheel well already out. There are a few push-pin fasteners connecting the front facia to the facia retainer on the frame.
Then lift it off the support brackets (by the headlights and in front of the radiator area).

That should do it.

 

[Wifey]

Using a grease pencil (or masking tape and a Sharpie), mark where the current cover is set. Or you can just measure the gap(s) and write 'em down. This will help with alignment when re-installing.

It sounds like you have the belly pan screws and the 3 screws from each wheel well already out. There are a few push-pin fasteners connecting the front facia to the facia retainer on the frame.
Then lift it off the support brackets (by the headlights and in front of the radiator area).

That should do it.

WOW! - you go Kevan . Not only are you EXCELLENT AT PHIL UPDATES, you freaking know your bumpers, too! :rock:

 

[Kevan]

Thanks. Just tryin' to help out.