Heads,intake,exhaust????

[Tooloe]

ok guys heres whats up... i got my heads back from the machine shop... i did a 3 angle valve job and some light porting and polishing..had it portmatched to the intake..well i got to messing around with all my gaskets the other night and noticed that the exhaust side of the head could use a little trimming and smoothing up..so off i went.....then after that was done i checked out the intake..and thought to myself.. why would you port match the heads to the intake when the intake isn't matched to the heads...so out comes the dremel tool...well a few late nights and frustrating polishing...all is good.. now do yall tihnk i'll see a diffrence in performance? i mean i know every little bit counts... and i'v portmatched every thing but the stock manifolds and am thinking of doing those..... i know it sounds like i got bored but my cam is on back order until april 15th so like i said with everything port matchd and a good cam will i se a good gain in hp and tq?

 

[Yellow venom]

Should definatly be better,more flow more rubber!LOL,I mean power!
Do you have a dyno run from before?

 

[Tooloe]

no i do not i was sopose to have it on the dyno a week after i blew the #10 piston to pieces lol

 

[JTS VENOM PERFORMANCE]

In most cases port matching can make up to a 20hp difference, good job:rock:

 

[Tooloe]

Sweet! thats the kinda news i like to hear lol

 

[bigike]

Good job! I see people say the gasket match thier heads, and I always thing what about the intake, headers...................not this time thou you got'er dun

 

[Bone]

More air in, more air out...

 

[Tooloe]

ok heres the before and after shot....
these arent polished out of even sanded down inside the tubes yet lol


Before/Stock

An After/A little bordem

i'm still debating on takeing a 5th pass at these heads lol...iv just been moving slow and making sure not to screw anything up....what do you think?

an again these aren't anywhere near done i willo back and straighten all the cuts back out... and sand the inner part and polish it out

 

[kyle's srt10]

Looks good:rock: I done the same with mine last year when I done the cam swap Between the heads and intake it took me several days

 

[nycstev]

make sure you get every last piece of metal shaving cleaned up!

 

[Tooloe]

yeah i know moms throwing a fit about the shavings lol

 

[sleeper]

Your should of took you heads apart first. Now you have to disasemble them and clean everthing really fkn good. Then put it all back together correctly.
Have fun.

 

[Tooloe]

iv got the heads all cleaned up i used a trick most of the oil burning guys use.... a vacume with a straw attached to it.. the heads will be spot less when im done on the inside