how to take intake manifold off?

[DRamSrt10]

I know that thread had discussion before. I did use the search but I found some that arent good enough for me to get the answer that I need. I got MSD wires and I know I need to take the intake manifold off in order to change the wires. I dont want to screw up or anything. I would like some of the list to do and pix on how to take it off and which bolts to take off. Any helps would be great! Thanks!

 

[DRamSrt10]

Anyone? :dontknow:

 

[Begood]

You have to unbolt the throttle body and disconnect the throttle linkage and sensor, than you remove the fuel line from the fuel rail, than you remove the intake bolts which are hex head and torx head, than lift the manifold straight up. It can be a pain in the ass so take your time.

Bill.

 

[Nowwhat]

Step 1) go to a viper tech

Step 2) see step 1

 

[Prof]

You should try it with a top mount twin screw!

 

[Dave T(BADVENM)]

I know it (intake) weighs 25 pounds

 

[includemeout]

Step 1) go to a viper tech

Step 2) see step 1

I did and he gave me some hints and said: " Unless you are a Shampoo Salesman from Malibuuuu....... you can do it your self, it does not take a Rocket Scientist"

 

[DRamSrt10]

Alright also i found that the bolts is 11mm each and i would need wrench. Correct?

 

[DRamSrt10]

Can the gasket to be reuseable?

 

[belgiumbarry]

You have to unbolt the throttle body and disconnect the throttle linkage and sensor, than you remove the fuel line from the fuel rail, than you remove the intake bolts which are hex head and torx head, than lift the manifold straight up. It can be a pain in the ass so take your time.

Bill.

sorry if look silly but i tought there's another way :

............ hold the intake manifold and pull the truck down......


sorry,
Barry