Midpipes or Coils & Wires

[NVR2OLD]

Each year I like to add something new to my truck. I been think about Midpipes or coils & wires and mybe both for this year. The Bassani Headers are so damn expensive compared to Midpipes and coils & wires. Whats the best way to go Guys???:dontknow:

 

[FATJACK]

Cat delete mids are good for about 25 hp and cheap. Especially of you can con a local muffler shop in to building them for you.

 

[ZCx]

can ya do the cat deleate with the coils, wires & fresh plugs:rock::rock::rock::burnout::burnout::burnout:

 

[RAMDUDE]

Cat delete mids are good for about 25 hp and cheap. Especially of you can con a local muffler shop in to building them for you.

X2 yeah remove the cats is a notice that I seen.

 

[NVR2OLD]

Sounds like the best way to go is to buy Midpipes from JMB and bolt up to my Magnaflow and keep my stock pipe & cats to bolt back up if need them. Than add coils & wires and plugs from JTS. I just hope the Midpipes don't make the truck too loud. Thanks Guys...

 

[RAMDUDE]

Sounds like the best way to go is to buy Midpipes from JMB and bolt up to my Magnaflow and keep my stock pipe & cats to bolt back up if need them. Than add coils & wires and plugs from JTS. I just hope the Midpipes don't make the truck too loud. Thanks Guys...

define to loud, it's going to open her up, will be louder for sure.

 

[NVR2OLD]

define to loud, it's going to open her up, will be louder for sure.

"define to loud"... Like driving down the HWY talking to my wife without yelling or her yelling back.

 

[RAMDUDE]

No not that loud.

 

[yellowfever#154]

"define to loud"... Like driving down the HWY talking to my wife without yelling or her yelling back.

Isnt that normal even without the exhaust noise?

Do the mids for sure, best bang for the buck.

 

[amtrucker22]

Do the mids and save yourself from the dreaded B1tch of a bolt on the back of the manifold.

 

[JTS VENOM PERFORMANCE]

wires, coils, plugs , to me are considered normal maitenance, so depends on what you are wanting to invest in, hp or reg maintenance, either way you come out with gains

 

[kyleblix]

Quick question regarding this, Is a tune needed if you remove the cats?

 

[FATJACK]

Roz removed his cats with no tune and got 460rwhp on the dyno with good a/f numbers.

 

[kyleblix]

I'm guessing you would just want to disconnect the battery for a few minutes after removing the cats to let the ECU reset and then re-learn??

 

[FATJACK]

He used anti-foulers for the front sensors and wire tied the rears to the frame.

 

[amtrucker22]

I thought you were suppose to leave the front sensors alone and put the anti-foulers on the rear. That is how I have mine.

 

[Ironhead]

I thought you were suppose to leave the front sensors alone and put the anti-foulers on the rear. That is how I have mine.

you are correct sir ,,jack is a tad off ,,,:rock:

 

[kyleblix]

Thanks guys. I'm still learning about these trucks.

 

[FATJACK]

you are correct sir ,,jack is a tad off ,,,:rock:

My bad memory again....