Need a favor

[outnumbered]

Could someone with a QC, that has not lowered their truck, please get a pinion measurement on top of the hogs head, as well as the driveshaft where it meets the tranny? I'm trying to get stock measurements so I can adjust mine accordingly.

Thanks,
Ron

 

[JTS VENOM PERFORMANCE]

Could someone with a QC, that has not lowered their truck, please get a pinion measurement on top of the hogs head, as well as the driveshaft where it meets the tranny? I'm trying to get stock measurements so I can adjust mine accordingly.

Thanks,
Ron

bring your butt to maiden

 

[outnumbered]

bring your butt to maiden

Are you going to be home tomorrow?

 

[includemeout]

angles

Here you go

 

[outnumbered]

Here you go

Thanks, but I have those. Just trying to get an actual number. Going to see if the service manual numbers do the trick.

 

[outnumbered]

Here you go

So according to the manual, "C" should be at 4.9^, while "A" should be at 3.0^?

I was always under the impression that the rear section had to be at -4^.

 

[JTS VENOM PERFORMANCE]

So according to the manual, "C" should be at 4.9^, while "A" should be at 3.0^?

I was always under the impression that the rear section had to be at -4^.

should you got the number

 

[outnumbered]

should you got the number

HuH??

 

[includemeout]

Maybe this will help ,This is the all the manuel has on the subject that I can Find

 

[TheSickness]

I'm Cornfussed