New Custom Pressure Plate and Alum Flywheel are AWESOME!!!

[VENOMOUS1 RACING]

Got around to finding the vibration in my truck and found the Centerforce PP had sprung out of center so I had done a little research for an even stronger PP to replace it with. They are all using factory type Pressure Plates and modifying them to their specs. So I had a custom PP made up to run in my 10 as an experiment and so far after only 30 miles I LOVE IT!!! I also added an ALUMINUM FLYWHEEL against everyone here's advice and again, it's the BOMB! All the drama about having to rev high to take off is BS! There is no difference whatsoever in daily driving, traffic, anything! The only difference is the ability to spin the engine faster therefore getting from 0-60 faster
I am so totally happy with the results! May have to offer the package up for sale soon. Vendor status may be in my future guys:rock::dontknow:

 

[JRSVIPR]

Cool, Thanks for the info. Good to know.Also good luck with your venture.:rock:

 

[yellowfever#154]

Is it a billet pressure plate?

 

[VENOMOUS1 RACING]

Not yet
Thinking of going that route but this one weighs the same as factory.
An alum PP would be awesome if I can figure that one out

 

[Hemitime1]

That's awsome. I debated for a long time about going with a light weight flywheel. Most of the challenger after markets are aluminum and they aren't exactly a light car either. I think around 4200ish. Makes me wish I would of wenrt aluminum.