New PB
- Thread starter ARRESTmeRed04
- Start date
ARRESTmeRed04
Active Member
Nice, I'll prob hold off on the track for the rest of the summer, what was your 60' and what rear tires are you running
RagunCajun
Full Access Member
28" full hoosier slicks. 1.839 60'
I'm going back as soon as i am able. Trying for saturday. I know my 1/4 will suffer but i need to nail this 60' down. 1.8 is not acceptable for me. I want 1.5x or less or else.
It's nice to see all motor running 115mph. My trucks built, heads, cams whipple lol. Damn heat kills these trucks.
I have more in it but i want to get my 60' down. It was my first time with the set up. Lots more to learn.
I'm going back as soon as i am able. Trying for saturday. I know my 1/4 will suffer but i need to nail this 60' down. 1.8 is not acceptable for me. I want 1.5x or less or else.
It's nice to see all motor running 115mph. My trucks built, heads, cams whipple lol. Damn heat kills these trucks.
I have more in it but i want to get my 60' down. It was my first time with the set up. Lots more to learn.
ARRESTmeRed04
Active Member
28x14.5x16 quick time pros? That's the same tire I'm running I'd be happy with 1.6x 60's. I'm going to go over the truck make sure everything is like it should be. Got about another 100lbs I can take out of the rear. What tire pressure were you running
RagunCajun
Full Access Member
I went to 17psi after my first run.
I personally would use my set up for recommendations. I'm learning as I go. I was told slicks aren't the best since the sidewall isn't as stiff as a nice drag radial. But time will tell.
As for the tire size, it says 28.0/10.0/16. Hope that helps.
I personally would use my set up for recommendations. I'm learning as I go. I was told slicks aren't the best since the sidewall isn't as stiff as a nice drag radial. But time will tell.
As for the tire size, it says 28.0/10.0/16. Hope that helps.
Knock it off....I guess I may have to make a few runs with my stock doors and seats.
ARRESTmeRed04
Active Member
Would be interesting to see how much it'd slow you down, maybe .15-.2?
Probably more....doors (180lbs), tailgate (60 lbs), seats, armrest, subwoofer, package tray (130 lbs)....equals 370 lbs, by rule 100lbs = .1 so maybe .3 to .37 difference. My best 11.66 plus .3 = 11.96.......might be a challenge, but like you are guessing maybe .2 so I could hope for an 11.86 at best.
I'm impressed with the times you got, and the fact you ran them in Texas... can't imagine the density altitude being that good this past weekend. It was downright hot up here where I am. But low-12s @ 115mph with your mods is outstanding.
nice runs!!
maybe i'll just get some slicks and say F it, lol
maybe i'll just get some slicks and say F it, lol
noid
Full Access Member
Nice job. Nice seeing someone else running similar times.
ARRESTmeRed04
Active Member
Da started out at 2300 and was at 1950 for the 12.08 pass.
Noid what was your trap speed again?
RagunCajun
Full Access Member
Id like to see you run it how you drive it on the road. Just do a wheel/tire swap so you hook.
ARRESTmeRed04, you were power shifting every run? I need to start doing that at the track. Last time i went 12.3 @ 111 powershifting. Damn 2-3 haunts me
ARRESTmeRed04
Active Member
Id like to see you run it how you drive it on the road. Just do a wheel/tire swap so you hook.
ARRESTmeRed04, you were power shifting every run? I need to start doing that at the track. Last time i went 12.3 @ 111 powershifting. Damn 2-3 haunts me
No powershifting, don't feel comfortable with the new clutch setup yet, its a totally different feel than it used to have
RagunCajun
Full Access Member
What clutch ?
noid
Full Access Member
Here is the run info:
1.768
4.987
[email protected]
10.137
[email protected]
Mods are:
Mopar long tubes into 3"
2400 stall torque converter
sct
cal tracs
fastman tb
no cats
volant intake
dr's
trainmans old skinny fronts
no tailgate, cover, or rear seats
RagunCajun
Full Access Member
Another prime example of mild trucks putting their power down unlike the big HP dyno queens.
ARRESTmeRed04
Active Member
Mine is just a canned tune from Torrie, spec stage 3 or stage 3+ can't remember now its been so long
RagunCajun
Full Access Member
We have the same clutch
Support Us
Become A Supporting Member Today!
