OBD2 port not working

[Mighty1]

Had the aeroforce gauge plugged into that port and was working fine then went off. I thought maybe something was wrong with the gauge so I plugged my SCT into that port and it won't come on either.

Any ideas what I should check for? I don't see a fuse for that port unless it is called something else.

 

[wesalbert]

Make sure all the pins in the OBD connector are still in. There was a member who I helped because his pins came out of the connector.

 

[Mighty1]

All of the pin receivers look like they are there although there is not a receiver for every slot. I just pulled every single fuse and all were good as well.

 

[wesalbert]

OBDII - On-Board Diagnostic's System - Does My Car Have OBD-II? The Connector and Communications.

I would take a multi-meter to pins 5 and 16 to see if you have power. DO NOT USE A TEST LIGHT

 

[Mighty1]

Well it started working again for some reason. Not sure what happened.
Thanks for the help!!:rock::rock:

 

[err76]

Check all your fuses, especially the one for accessories.

 

[rare03srt10]

Yea i think there may be a fuse for the OBD2 port if not like err76 said may be one of the accessory fueses but kinda odd that it started working again lol. fuses dont unpop lol