P/S 1' valve fitting removal.

[VIPER-INJECTED]

Hey guys, I'm stuck out here in my storage unit trying to get the 1inch fitting off of the pump to install the JTS p/s lines. I already installed the line the fitting on the pump is the only one I need left. I there any special tool to get it off. I have a 1' six point deep socketdoesnt work. I can't get this fitting off. Thanks.

Trying to install the updated valve fitting.(BELOW)

 

[Overkillsrt]

I used a wrench but it sits at kind of a upward angle and the fitting was crazy tight

 

[mysrt10]

12" crescent wrench FTW!

 

[VIPER-INJECTED]

Yea, I'm running to the parts store right now.

 

[trussman]

Glad you asked bc I plan on pulling my lines soon. Post up what works best.

 

[ViPeR_PiLoT]

Try a crows foot.

 

[ZCx]

i used a deep socket, 1/2 extension & long breaker bar.

loaded it up till there was a good bow in the breaker bar & then popped it

anybody ever try an impact:dontknow::dontknow::dontknow:

 

[VIPER-INJECTED]

Glad you asked bc I plan on pulling my lines soon. Post up what works best.

Will post up pics tomorrow of the tools used. Overall the lines/fittings were not that hard to put on.

 

[VIPER-INJECTED]

Installed fitting.



Some of the tools I used will post more pics of other tools, just showing for ppl that don't know. If you have ?'s ask.
-used this electric impact its rated @ 60 ft lbs applied TQ, to pull underside splash guard. Prob best tool I use everyday.


Used this to pull 13/16 pressure line fitting nut off 1' fitting on p/s pump assembly.(used a longer extension *not pictured)

 

[VPRPWRD]

Try a crows foot.

That's what I was thinking....

 

[VIPER-INJECTED]

Here are some other tools. Finished up the truck tonight. I used some metric tools, I mainly work on Honda/Nissan vehicles.








DONE!!!!!!