Power steering not working

[SANTEEN]

Was out driving today and noticed that the engine temps were a little higher than usual. As I slowed down, they climbed higher. When I went to turn off the expressway, I also noticed that I had no power steering. Pulled over and popped the hood. Fan wasn't working, so I checked the p/s fluid level. It was full and I could see the fluid moving in the reservoir, while the engine was running. So, I'm assuming the pump is working. Any ideas? I'm thinking that some how the module that the fluid goes through in the back of the fan, has gone bad?

 

[hankthetank]

wish i could help ya bro, since i'm always bugging you...

 

[REPOMAN1]

Is it leaking ? Mine did the same thing i just ordered the new lines . It was leaking from the bottom of the box

 

[viperhauler]

just go drive off a bridge...i'll take care of joy...that'll fix it...:aetsch:

 

[FastRam]

I'm not sure either but I hope the fan module is NOT the problem. That sucker is expensive...

 

[rare03srt10]

When i did my build the fan and module that i ordered accually didnt work and i had the same problem. The guy i bought it from was cool though and he send me a replacement module which fixed it so Yes that could be your problem if nothing leaking and the pump is working....

 

[Black1]

These trucks have the most rediculous fan setup... Hope it's nothing major, Santeen. :dontknow:

I know Justin at JMB has a nice electric fan kit, if you want to get rid of all that stock nonsense.

 

[rare03srt10]

These trucks have the most rediculous fan setup... Hope it's nothing major, Santeen. :dontknow:

I know Justin at JMB has a nice electric fan kit, if you want to get rid of all that stock nonsense.

Thats the route i would take. The hydro setup is a JOKE and going electric would be much cheaper in the long run probley

 

[Black1]

Thats the route i would take. The hydro setup is a JOKE and going electric would be much cheaper in the long run probley

JMB Performance & Powdercoat, LLC

:rock: