rear inner fender wells

[VIPR PWR]

Where can I get a set of full rear inner fender wells for the srt10....I saw one at a dealer and it helps make the truck look better at the rear whell wells...anyone done this ---Cost ?
link to ones I found .....says they don't fit the srt.....this is what the ones I saw looked like ----http://www.autotrucktoys.com/ram/Mopar-OEM-Dodge-Ram-Rear-Wheel-Well-Liners-02-09-P8292C1669.aspx#

 

[TNVIPER]

PM Stinker...

 

[moparracing]

once i lowered my truck, i didn't see a reason for inner liners because i couldn't see them anyways........

 

[TNVIPER]

once i lowered my truck, i didn't see a reason for inner liners because i couldn't see them anyways........

Is yours the 1/2 or 2/4 kit?....I have the 1/2 and the wheel wells still help some..

 

[ZCx]

got them on mine.

mine is down 1/2. with the liners looks lower

love them.

if its the same ones i got, from Dodge, they say won't fit because of tire rub.

 

[FastSRT19]

I have the Dodge rear wheel well liners on my truck, they fit just fine, and i have the 1.5 inch lowering blocks too. Only a very minor rub on hard cornering, not enough to worry about.

 

[SANTEEN]

Anyone got part numbers? How is the install?

 

[wesalbert]

Anyone got part numbers? How is the install?

Lower that thing and you wont have to worry about it

 

[SANTEEN]

Lower that thing and you wont have to worry about it

I would, but I keep hearing about vibrations on the '06 QC when it's lowered.

 

[wesalbert]

I would, but I keep hearing about vibrations on the '06 QC when it's lowered.

oh whats a little shake

 

[ZCx]

I would, but I keep hearing about vibrations on the '06 QC when it's lowered.

get an '05 RC:dontknow: :dontknow: :rock: :rock: :burnout: :burnout: lol

 

[wesalbert]

http://www.vtcoa.com/forums/showthread.php?t=15775&page=2&highlight=wheel+liners

Go to post 16. I'm wondering if a heat gun and a 2x4 would help. :dontknow:

 

[Prof]

I have them...

Down three inches in the rear.

They rub just a little bit...I cut a small portion off the driver side liner, with a Dremel tool.

Any dodge dealer can get them for you over night. They are not recommended for the SRT 10 but they work and look super.

Install is nothing.

Just Do It!

 

[SANTEEN]

No part #'s. My dodge dealer has a bunch of idiot's working there. I usually walk in with a part # and tell them what I need.

 

[Prof]

I think this is it:

82207367-AB

Liner Kit 1020001

My dealer gives me a discount, it was 97.20

I think this is for all four wheels...

By the way, I have two front liners never used...if anyone needs them and the used rear partial liners...

 

[moparracing]

Is yours the 1/2 or 2/4 kit?....I have the 1/2 and the wheel wells still help some..

no kit, drop shop did a 2/3...... :rock:

http://www.vtcoa.com/forums/showthread.php?t=22329&highlight=drop