Stinkers Drop Blocks!

[JeffBoyette]

Shout out to stinker.. Great product, even better service, and best price! But what can i expect from a fellow carolinian?

Installing my 2" drop blocks this weekend. Are there any tips tricks advice or warnings, before i get started? Thanks for all your inputs! Cant wait to be sitting level.

 

[FATJACK]

Nuttin' to it, you will be finished in 45 minutes, start to finish.:rock: :rock:

 

[GriffsSRT]

It's easy.......just make sure you have a tall enough jack..good luck with the install

 

[JeffBoyette]

The blocks are angle cut to help with the pinion angle right? If so which way goes forward the short side or the tall side?

 

[JTS VENOM PERFORMANCE]

On the RC's you dont have to worry as much about the pinion anlge you shouldnt get any driveline vibration

but raise the truck and support it by the frame or just under the spring at the axle .

remove the u bolts, then with a jack slowly raise the axle , slide inthe blocks making sure you locate them on the pins, lower tighten , done

 

[JeffBoyette]

loctite?

 

[Roz]

loctite?

Negative.

Do not over-torque the bolts either. You don't want the your bolts to twist and break.

 

[spdrcrj]

When I did mine, I could not get the stock blocks off the spring. I went to the Hurlburt auto hobby shop and we did something like raise the pumpkin. I cant remember exactly. Talk to Danny or Dan and they will know what your talking about.

When I get home, I'm removing the spring pads Stink sent with my springs and going with 2.5" drop blocks......to be installed with his Caltracs kit.