T&D Roller Rockers

[kyle's srt10]

Where can I get some of these at:dontknow: Or which are the best to run

 

[ViperTruck2933]

The T&Ds are made by T&D Machine. I ran them on my truck and they were great. Jesels are the best of the best but cost more than T&Ds. I would not run Harland Sharps. I have heard bad things about them.

Gen II T&Ds can sometimes be found for $300-$500 less than Gen IIIs. A good Viper tech can put the Gen II T&Ds on the Gen III motor but only if he knows exactly what he is doing with the geometry. Joe at PBJ put the Gen II's on my truck.

 

[BurntRubber]

The T&Ds are made by T&D Machine. I ran them on my truck and they were great. Jesels are the best of the best but cost more than T&Ds. I would not run Harland Sharps. I have heard bad things about them.

Gen II T&Ds can sometimes be found for $300-$500 less than Gen IIIs. A good Viper tech can put the Gen II T&Ds on the Gen III motor but only if he knows exactly what he is doing with the geometry. Joe at PBJ put the Gen II's on my truck.

Brand new Harland sharp are good for up to 700rwhp. I personally spoke to Sean Roe and he said they are just fine with there blower and a 10# pulley. The ones from a few years back are crap, but they have a new manufacturer.

 

[Bone]

I also heard Jessels are the best for our motors. Most expensive too.

 

[BurntRubber]

I also heard Jessels are the best for our motors. Most expensive too.

yep, and there are different kinds, Stiker has a set manufactured for there heads. Mohawk are a straight application