Tremec Output Yoke

[Chuck B]

I'm now just shy of 100K and rear trans seal is beginning to weep a bit again. Last time I replaced the seal but it continued to weep. Pulled the yoke and sanded with wet/dry and its been fine till just recently. Looking to see if there are aftermarket alternatives as a yoke replacement. THIA!

 

[JTS VENOM PERFORMANCE]

oem I can do for $119.99 prob $10 shipping, but just got off the phone with DTS and we went thru all they had and come up empty, got close on a 30 spine yoke ,but no potatoes

 

[JTS VENOM PERFORMANCE]

just checked with unitrax, oem deal with them also

 

[Chuck B]

Thanks for checking.... I know of a couple for the Viper but not for Ram application. I have no issue with OEM but wanted to see of other options are out there.

 

[includemeout]

Thanks for checking.... I know of a couple for the Viper but not for Ram application. I have no issue with OEM but wanted to see of other options are out there.

Try these guys Don't know if this will work, but they can probably fix you up

http://www.dennysdriveshaft.com/p29...__a833_manual_and_t_56_viper_with_2930_s.html

1350 Series 727 auto & A833 manual and T-56 VIPER with 29/30 spline output
Part #: SY1350-727 $79.95 $62.95 each
THIS ITEM IS ON SALE!

Click for Larger Photo Status: In Stock, Usually Shipped Within 2 Days
$79.95 $62.95 each
Add to Shopping Cart
Click Here to Buy Online
1350 Series 727 auto & A833 manual and T-56 VIPER Spicer Transmission Slip Yoke with 29/30 spline output.

Length to center of u-joint... Dimension #1 = 6 5/8 inches
Barrel Diameter... Dimension #2 = 1 11/16 inches
Barrel Length... Dimension #3 = inches
U-joint cap diameter... Dimension #4 = 1 3/16 inches
U-joint width... Dimension #5 = 3 5/8 inches
Series... 1350
Spline count... 30

 

[JTS VENOM PERFORMANCE]

inch and a half too short

 

[includemeout]

Worht a try , they may have what is needed :dontknow:

 

[JTS VENOM PERFORMANCE]

yeah I think the oem one is right at 8 inches long

 

[includemeout]

yeah I think the oem one is right at 8 inches long

Just measured my 1400HP rated one and it is about 8" But those guys at:
http://www.dennysdriveshaft.com/p297...th_2930_s.html
May still be able to come up with one, like I said worth a try................

 

[JTS VENOM PERFORMANCE]

most def, anything is worth a shot