Viper Factory
- Thread starter LoveThisTruck
- Start date
Kewl vid! 
FATJACK
Full Access Member
That is neat!!
moparracing
Full Access Member
cool.
Do you guys think that that is where they put the motors in our trucks? Maybe they should of hired a robot to tighten down the pulley bolts.
kickinassrt-10
Full Access Member
I doubt they put it in the truck..I'm surprised our motor's are hand built though! That's cool
NorCal SRT-10 said:Do you guys think that that is where they put the motors in our trucks? Maybe they should of hired a robot to tighten down the pulley bolts.
Our trucks weren't even built in this country lol
black pearl
Full Access Member
Great video:rock: :rock:
andrew heywood
Full Access Member
I think they tried to immulate that facilty in saltillo mexico, maybe did't pay as good of attention to detail as the true viper facility. and I'am sure there was'nt to many viper techs on hand. ...............sarge, this is a bitchin find......:rock: :burnout: :rock:
Very cool. What generation motor were they showing? I like the look of the intake manifold and valve covers being in a flat configuration.
Next question would be, will that motor go in our trucks, sorry for the newbie questions.
nycstev
Full Access Member
Great video . Thanks!
those were gen 4's...8.4L's...600hp i think...
i think there was discussion about the swap, and a lot would have to be changed...computers, mainly...
i think there was discussion about the swap, and a lot would have to be changed...computers, mainly...
kickinassrt-10
Full Access Member
Those are definitely gen 4 engines.....That was probably the only thing hand built on out trucks!
If the techs at the Mexican factory were anything like my family that still lives in Mexico.. they were drunk when building our trucks. :cheers: :cheers:andrew heywood said:
Support Us
Become A Supporting Member Today!
